Tag Archives: breakout board

Interfacing a Hall-effect current sensor with an Arduino

Current flow in a system is depends on load characteristics. Due to a faulty condition or controlling scheme, the current flow in the system might be changed. So having knowledge about the current flow in a system is important for both protection and controlling purposes.

There are various methods available for sensing current flow in a system. Usage of shunt resistors, current transformers and usage of Hall-effects sensors are some such available methods. This articles talks about usage of Allegro ACS712 sensor [1] with an Arduino development board for measuring current in a system. Allegro ACS712 sensor operates according to the Hall-effect principal and it can be used for both AC and DC current measurement. There is no need of auxiliary circuits for this sensor it is an immense advantage over the other available methods.

What is Hall Effect principle?

“The Hall-effect is the production of a voltage difference (the Hall voltage) across an electrical conductor, transverse to an electric current in the conductor and a magnetic field perpendicular to the current. It was discovered by Edwin Hall in 1879.”[2]

Allegro ACS712 sensor

This is a bi-directional measuring device and therefore this can be used for both AC and DC current sensing. The ACS712 sensor is designed for three current ranges 5A, 20A and 30A. The sensor consists of an integrated circuit which works according to the Hall-effect principal. This IC generates a voltage proportional to the current flowing in the circuit. Breakout board of current sensors based on this device also available in the market and they make your life easier.

Following graph show the variation of the output voltage with the current flow for 5A sensor [1].

Interfacing with Arduino

Connection configuration

T1 and T2 of the sensor should be connected in series with the current path which is need to sense. Out pin should be need to connect one of the analog input pin available in the Arduino. VCC and GND pins should be connected to 5V and GND pin of the Arduino respectively.


The sensor outputs an analog voltage correspondence to the current flow. Therefore to get the current reading from the Arduino. So we need to perform analog to digital conversion inside the Arduino and multiply with calibrating constant to get the actual value.

We need to use little bit of mathematics for the actual current value calculation. Adruino has 10 bit analog to digital converter register. So ADC value is in range of 0-1023. Then the actual sensor voltage output can be obtained from

OutputSensorVoltage = analogRead(sensorPin)*5.0/1023.0

From the graph and the datasheet,

At zero current, OutputSenosrVoltage = 2.5

Gradient of the graph = 185mV/A (given in datasheet as sensitivity)

So the equation of the graph is

OutputSensorVoltage = 0.185*Current + 2.5

Therefore current can be expressed as

Current = (OutputSensorVoltage – 2.5)/0.185

If the current flows in negative direction, current value will be negative.

Following is an example code which can be used for measuring current using the sensor. It will display the current measurement on serial monitor.